Portable Ice maker troubleshooting Guide
Where regular refrigerator limits the amount of ice usage, best portable ice makers let you enjoy the solace and fresh provided by the unlimited amount of ice. However, when these relief providers give you trouble, then you need someone or something to give step by step guide to get rid of the problem.
When Ice maker doesn’t make Ice
Sometimes ice maker stops making ice in this case at first check the water level. Before doing so turn off the ice maker and then test the reservoir. Pour some water to refill it. Do it if only the water level is low. Then check that your unit is powered by direct water line connect or not. If yes, then confirm that the water is flowing freely into the unit.
Alternatively, you can try these steps too first, inspect the water supply then test the shut-off switch. Finally, check the freezer temperature.
Also, often ice maker stops producing ice when the ice bin is full with ice. Whenever the shutoff arm seizes to function, it signals that your ice been might be full! The shutoff arm elevates up to the bin to place the ice cubes during the ice making cycle, after that it goes down back to its normal position. The arm cannot come back down until the ice bin is emptied. The pile of ice in the bin stops it from going down. To solve this problem, try turning down the shutoff arm manually by putting into a lock position. This will ensure the safety of the arm and will retrieve its normal operation. Then go through the manual instruction of getting back its normal position. Lastly turn on the ice maker to recheck its function.
When Ice Maker doesn’t turn off
You might face this problem once in a while that the ice maker does not turn off even if you are pushing the turn on and off button. This issue might me caused by a timer which is found on many ice maker. The timer allows the machine automatically turn itself on or off whenever it senses that the ice bin is empty or full. But often a time for some wrong adjustments it starts or shuts down on its own. For solving this problem set the timer when you need only. At night keep it unplugged, turn it on in the morning and set the timer according to your convenience. Set the timer in 2 to 3 hours gap so that the ice maker can signal that when it needs water to be refilled and when you should empty the ice bin.
If the timer is not causing this problem check the shutoff arm. Notice if there is an abnormality with its positioning. You can always readjust the position of the ice maker just using your bare hand. Also, push the shut off switch to shut down the machine completely.
When Ice maker supply line is frozen up
Never ignore a frozen up supply line of your ice maker. Ignoring this problem will result in complete cease of ice production. These simple but easy to follow solution will help you to solve this problem effortlessly. The first solution is to power down the ice maker which will allow the ice inside the power supply to melt. Keep the unit in this way to let the ice melt away completely.
The other solution can be taking out the ice maker supply line from the machine and keeping it into the sink for a while to allow the ice to thaw entirely.
Another solution can be……..
When you must replace the ice maker
We want things especially our necessary gadgets to last forever! But this is not possible. Whenever you see that the power unit is completely broken down, and it will be a total waste of money if we invest money for repairing it, just stop trying and buy a new one. Before buying go through the reviews and customer feedbacks and buy the top rated products.
10 Best useful tips for troubleshooting Portable Ice Maker
- Always unplug the power cord before beginning any troubleshooting
- Check all the plug-ins and connections.
Sometimes just simple checking of the plugs-ins and connections can save your valuable time and money. Just check that all the connections are plugged correctly or nor.
- Keep a close eye on the water level.
- Make sure that the Ice does not overflow or get stuck/blocked
- Inspect the water sensor
- To stop leaking from the Drain pot
Just by placing the silicon drain plug back again in the silicon drain cap assembly you can resolve this issue
- Resetting the Ice maker
Start by unplugging the ice maker/unit, move the ice case smoothly all the way forward with your bear hand ( if needed use both hands) while doing so you will a zipping noise with some resistance which is entirely okay! Then push the case in its previous position correctly. Once the ice case is in its right place, plug the unit back in and turn on the ice maker
- Compressor makes a buzzing noise:
The voltage might be low or fluctuating. Switch off the icemaker. Before restarting it let the energy comes back to normal.
- Ice might seem cloudy or foggy
Cleaning should be done on regular basis and in the right way: Occasionally the ice from the ice maker might have an unpleasant taste or poor taste. In this case give the ice maker a proper and thorough cleaning. Before any cleaning always turn down the unit (ice maker), then take out all the remaining ice from it. Using a soft cloth clean off the entire inside area of the unit but only after removing the ice tray. Consider washing or at least wiping down the tray itself before placing it back into the premises. To thoroughly disinfect and to clean up the calcium buildups use two tablespoonful vinegar or lemon juice for running a couple of cycles. Give the ice maker final clean up by wiping its outer surface with a soft cloth.
Best tips for maintaining an ice maker
- Make sure the portable ice machine is kept in a cool place and a moderate temperature. An average temperature can be ranged from 40 F to 90 F. Also never expose the machine to too much heat. Keep the device away from stove, grill or any other hot surface.
- Weekly cleaning is mandatory for the ice machine to keep it in the best shape. Make sure to use liquid bleach to clean up the mold growth
- Air filters need the regular clean up as well. The amount of ice can be decreased if any dust, grease or another dirt is stuck in the air filter.
- Ice maker storage bin and any drain pipes need frequent cleaning too to prevent mold growth.
- Keep the use of ice machine limited to the ice making only. Do not keep anything on the top of the machine.
- After a proper clean up always make sure to sanitize the storage bin and dispenser as we normally take ice directly from these containers
- Finally, when the cleaning is done, run all the cycles of your machine. The cycles include checking of the freeze and harvest times, noticing all the parts and the need for replacing any part. Always throw out the first batch of ice made after the thorough cleaning.
Hiring a Repair Specialist
This troubleshooting guide can help you to do instant and quick fixes which are not too complicated or technical. But always remember there are particular perplexing problems which can be only solved by the help of an expert or a specialist. These people exist for a reason, right! Do not take any risk by trying to take care of any technical problem on your own. You might as well lose the machine entirely. Therefore, call an expert as soon as you detect any special problem like that. Before calling them check whether they are certified or not. If possible hire them through some well-known agencies who provide a warranty of their services.
Portable ice makers are the easiest and quickest solution for getting soothing ice instantly. They work much faster than the regular refrigerator. In fact, they provide bullet shaped and hollow ice cubes which are perfect for any drink. So to take care of this little cool machine follow the above-described suggestions: keep it clean, regularly check it for any finding out any abnormalities and if needed call the specialist immediately!